current probe
英 [ˈkʌrənt prəʊb]
美 [ˈkɜːrənt proʊb]
网络 电流探针; 电流注入感应器; 电流探头; 电流指示器; 电流探棒
双语例句
- A new micro-controller based compensation method for remnant-voltage of the GMR eddy current probe was analyzed.
研究了以单片机为核心的GMR电涡流探头零电势自动补偿新方法。 - Design of High Strength Bolts Scanning Testing Imaging System Based on the Eddy Current Array Probe
基于涡流阵列传感器的高强度螺栓扫描检测成像系统设计 - Design of a Novel Pulsed Eddy Current Testing Probe Based on 3D Magnetic Field Measurement
基于三维磁场测量的脉冲涡流检测探头的设计 - The current probe, being led by the Australian Securities and Investments Commission, centres on share trading in Sundance resources and Bannerman resources, two Australia-listed mining groups that Hanlong is attempting to buy.
目前的调查由澳大利亚证券和投资委员会（asic）牵头，主要针对两家澳大利亚上市矿业集团sundanceresources和bannermanresources的股票交易，两家都是汉龙有意收购的目标。 - The discharge current of surface discharge under positive impulse is measured by using the current probe. And the quantity of electric charge and its variation in the channel of surface discharge are analyzed.
采用电流探针，通过测量正冲击下沿面放电的放电电流，进而分析了沿面放电通道中电荷量及其变化规律。 - Uncertainty Analysis for Calibration of Current Probe
电流探头校准的测量不确定度分析 - This paper presents a new method for measuring transfer impedance of arched surface current probe according as the theory of square coaxial transmission line with round center conductor.
利用内圆外方同轴传输线理论，提出弧面电流探头传输阻抗的校准方法。 - Calibration Device of Surface Current Probe
表面电流探头校准装置的设计及应用 - A surface current probe based on photoelectric conversion technique is presented.
本文介绍了一种基于光/电转换技术的表面电流探头的设计方案。 - Finally, the shielding attenuation of a coaxial cable is achieved by the S-matrix of an injection current probe.
在此基础上，利用注入电流探头对同轴电缆的屏蔽衰减进行了测试分析。 - The system allows metal tube, bar and wire to pass through the eddy current probe with variable high speed, and defects can be accurately located, marked and recorded.
该系统的特点是允许被测样品高速、变速通过涡流传感器，并能对缺陷进行准确定位、打标及记录。 - Surface Current Probe Based on Photo-Electric Conversion Technique
一种基于光电转换技术的表面电流探头 - In this paper, the factors which affected the performance of eddy current testing probe were analyzed firstly.
本文首先分析了检测过程中影响涡流换能器性能的各种因素。 - Time domain calibration of pulsed current probe
脉冲电流探头的时域标定研究 - An optical current sensing probe with completely closed optical path is designed, The formula which shows the relation between birefringence and the measurement are derived. Some important conclusions and experimental results are given.
设计了一种光路全闭合的光学电流传感头，推导出传感头双折射和被测量关系的解析式，得出了若干重要的结论，给出了实验结果。 - Influence of Magnetic Core Materials on Transfer Resistance Z_t in Current Probe
不同磁芯材料对电流探头传输阻抗Zt的影响 - The development and applications of eddy current testing in recent years, as well as the progress of eddy current probe and the developing tendency of eddy current imaging are described.
评述近年来国内外涡流检测技术的发展状态，着重介绍涡流传感器的最新进展及涡流成象技术新动向。 - The Finite Element Simulation of the Improvement in Remote Field Eddy Current Probe Structure
远场涡流探头改进的有限元仿真 - Detection of the fatigue cracks in oil drill set connector with screened eddy current probe
用涡流屏蔽式探头检测油田钻具接头疲劳裂纹 - PMT And Current Probe Methods Used for Studying Predischarge Process in SF_6 under Impulse Voltages
研究冲击电压下SF6预放电过程的光电及电流信号方法 - Based on the principle of eddy current sensing, the performance of the eddy current sensor probe is investigated for the application of measuring the gaps between curved surfaces.
针对曲面间间隙测量的实际应用，从电涡流传感器的检测原理出发，对传感器探头的测量性能进行了研究。 - The Influence of selection of Magnetic Material on Its Experimental Performance in Low Frequency Interference Current Probe
低频干扰电流探头中磁芯材料的选择对其检测性能的影响 - Development of the Special Eddy Current Probe for Sucker Rods Testing
抽油杆涡流检测探头的制作 - A dynamic model of measurement system is established through system identification method according to low frequency distortion of the current probe. This method is also used to correct the distorted output signal of the probe.
针对电流探头的低频失真，采用系统辨识方法建立了测量系统的动态模型，并对探头输出信号的失真进行校正。 - Automatic test technology of electromagnetic Susceptibility ( EMS) of Current Probe Injection instead of Radiated Field
电流探头注入替代辐射场的电磁敏感度自动测试技术 - The feasibility of the weld quality inspection is verified by simulating eddy current probe detecting weld defects case.
利用COMSOL有限元仿真软件模拟涡流探头检测焊缝缺陷情况，验证了焊缝质量检测的可行性。 - The difference between this SIW power divider/ combiner and others is that the probe-to-waveguide transition is achieved with the help of a current probe ( metallic via), which achieve power dividing/ combining.
这类电路不同于其它基片集成波导功率合成电路的一个特点在于它采用电流探针（金属化通孔）实现波导到探针的转换，从而完成功率分配与合成功能。 - Firstly, the GMR based ECT probe is developed. Then the automatic compensation method for zero potential of the GMR eddy current probe is studied.
为此首先对涡流检测探头进行研究，研制了基于GMR（巨磁电阻）传感器的电涡流探头，并实现了GMR传感器零电势的自动补偿技术。 - By studying the theory of equivalent circuit about eddy current probe coil, the conclusion is arrived that the output of sensor is relative closely to the electromagnetic properties of measured targets, which limits the use of eddy current sensor seriously.
通过对电涡流传感器探头线圈等效电路的理论分析，得出传感器的输出特性和被测对象的电磁特性有密不可分的关系，从而严重限制了传感器的使用范围。